Burstfire - Brass Shavings Catch Tray - For Burstfire 2 in 1 Machines

needed this a long time ago quick clean up

This fit perfectly and catches the trimmings. Easy to vacuum when done.

I have not used it yet but did set it on top of my unit. I just hope that the holes over the tooling sockets are small enough to prevent fine chips from falling through. But they look good.

what an awesome addition to the annealer. highly recommend this product

Sometimes a new product comes long that completely fills a hole in one’s life. I thought my case prep workstation was complete until I saw the newly released Brass Shavings Catch Tray. Based on my previous experiences with Burstfire Guns new product releases, I had to give this a try. In fact, I ordered both versions of the tray.
The production quality is superior, as we’ve come to expect. The drive motor holes lineup perfectly with each station, and the holding magnets snap into place with a satisfying snick! More importantly, the tray does its job with zero interference with the drive motors themselves. I know that I’ve prepped uncounted numbers of brass, and removed hundreds of primer crimps, but I didn’t realize what a pain it was to sweep up the brass and nickel shavings until I didn’t have to.
The only wish I have, if anyone out there has the capability…make narrower chamfer and deburr toolheads that would allow removing the trays without removing the tool heads.
Nonetheless, this tool does what it’s supposed to do, and it does it well. I keep a small camel hair brush on hand to sweep around the drive units to prevent any stray shavings from falling through the holes when I remove the trays without for emptying.
Now on my wishlist is a metal catch bin for annealed brass that matches the contours of the Burstfire 2 in 1 Annealer, so I don’t have to prop up my ultrasonic cleaner rack.